Operation; Checking The Battery Charge Level; Removing / Inserting The Battery; Turning On And Off - Deltafox DP - CAG 2015 Traducción Del Manual De Instrucciones Original

GB
the clamping flange and the
grinding tools must be made of
elastic materials e.g., rubber,
soft cardboard etc.
• Always reassemble the device
completely after replacing the
grinding disc.
Turn off the appliance and, before
doing any servicing, remove the
battery.
Wear protective gloves when
changing the grinding discs in or-
der to avoid cutting damages.
The grinding disc nut must not
be screwed too tightly in order to
avoid breaking the disc and nut.

Operation

Remove the battery from the
device before carrying out any
work on the power tool.
Checking the battery charge
level
The battery's (
cated by the charge state indicator (
The LEDs indicate the battery's charge
level. To do this, press the softkey (
of the charge level indicator (
red-yellow-green => Battery fully
red and yellow => Battery half charged
red => Battery needs
38
7) charge level is indi-
9).
charged
to be charged

Removing / inserting the battery

1. To remove the battery (7) from
the appliance, press the release
button (6) on the battery and pull
out the battery.
2. To insert the battery (7), place it
on the guide track and push it
back into the appliance. It will
audibly snap in.
Do not insert the battery until
the appliance is fully assembled.
Risk of injury!

Turning on and off

1. To switch the tool on, first push
the on/off switch (4) to the right
and then forwards. The on/off
switch can be heard locking
into this position.
2. Pull the On/off switch (4)
straight backwards to switch
off. The on/off switch (4) slides
into its starting position. The
tool switches off.
After switching on the device, wait until
the device has reached its max. speed.
9). Only then should you start with the work.
The disc still runs even after the
8) device has been switched off.
Risk of injury.
Trial run:
Always carry out a trial run before carry-
ing out your first grinding procedure and
after every disc replacement. Switch the
device off immediately if the grinding disc
is not rotating smoothly, if considerable
vibration occurs or if you hear abnormal
noises.