Deltafox DP - CAG 2015 Traducción Del Manual De Instrucciones Original página 34

GB
protective hood should protect the op-
erator from broken bits and accidental
contact with the grinder.
d) Grinders may only be used for the
recommended attachment options.
For example: Never grind with the
side surface of a cutting disc. Cutting
discs are for cutting material using the
edge of the disc. Pushing sideways on
these grinders can break them.
e) Always use undamaged clamp-
ing flanges of the correct size and
shape for the grinding disc you
selected. Suitable flanges support
the grinding disc and thus reduce the
danger of the grinding disc break-
ing. Flanges for cutting discs can be
distinguished from flanges for other
grinding discs.
f) Do not use worn grinding discs for
larger electric tools. Grinding discs
for larger electric tools are not set
up for the higher rotation speeds of
smaller electric tools and can break.
OTHER SPECIAL SAFETy INSTRUC-
TIONS FOR CUTTING GRINDING
a) Avoid blocking the cutting disc or
pressing down too hard. Do not
make any excessively deep cuts.
Overloading the cutting disc increases
wear and its tendency to tilt or block
and, with that, to kickback or break
the grinder.
b) Avoid the area in front of and behind
the rotating cutting disc. When you
move the cutting disc by itself in the
workpiece, in the event that the elec-
tric tool kicks back with the rotating
disc, it can spin directly towards you.
c) If the cutting disc jams, or you inter-
rupt your work, switch the device
34
off and hold it until the disc has
come to a full stop. Never try to pull
the cutting disc out of the cut while
it is still running, because it can kick
back. Identify and correct the cause of
the jamming.
d) Do not switch the electric tool on
again as long as it is in the work-
piece. Allow the cutting disc to first
reach its full rotational speed before
you carefully resume with the cutting.
Otherwise, the disc may catch, spring
away from the workpiece or cause a
kickback.
e) Support plates or workpieces to
reduce the risk of kickback from a
jammed cutting disc. Large work-
pieces may bend under their own
weight. The workpiece must be sup-
ported on both sides of the disc, near
the cutting disc as well as also at the
edge.
f) Be particularly careful for pocket
cuts in existing walls or other areas
where you cannot see what is there.
The cutting disc may cause a kick-
back when it cuts into gas or water
lines, electrical lines or other hidden
objects.
ADDITIONAL SAFETy INSTRUCTIONS
FOR SANDING
Special safety instructions for sanding:
• Do not use overly large sandpaper
sheets; follow the manufacturer's in-
formation for sandpaper sizes. Sand-
paper sheets which extend beyond
the sanding plate can cause injuries
and can block, tear the sandpaper, or
cause kickback.