Practical Tips; Scrubbing Wheels - Deltafox DP - CAG 2015 Traducción Del Manual De Instrucciones Original

ADDITIONAL SAFETy INSTRUCTIONS
FOR WORKING WITH WIRE BRUSHES
Special safety instructions for working
with wire brushes:
• Be aware that the wire brushes also
lose wire pieces during typical use.
Do not overload the wires by press-
ing down too hard. Flying wire pieces
can very easily penetrate thin clothing
and/or your skin.
• If a protective hood is recommended,
do not allow the wire brushes and
the protective hood to touch each
other. The diameter of plate and cup
brushes can enlarge if too much pres-
sure and centrifugal force is exerted.
Warning! Observe the safety
information in the operating
instructions for your DELTAFOX
20V Li-Ion series rechargeable
battery.

Practical tips

CAUTION!
With the protective cover pro-
vided, the tool may only be oper-
ated with the following wheels:
FORM 27 - Depressed centre
grinding wheel
FORM 28 - Depressed centre
grinding wheel - Bell shaped
FORM 29 - Serrated wheels
Cutting with this tool is only per-
missible when using the option-
ally available, closed protective
cover (see Spare parts/accesso-
ries).

Scrubbing wheels:

Never use a cutting wheel for
scrubbing !
Exert only moderate pressure on the
workpiece. Move the device evenly back
and forth.
A working angle of 30° to 40° achieves
the best results for scrub grinding.
Cutting disc:
Never use a scrubbing wheel for
cutting !
Only certified, fibre-reinforced cutting or
grinding discs may be used.
In general, work with small scrubs. Exert
only moderate pressure on the workpiece.
Always work in the counter-direction. This
ensures that the device is not pushed out
of the cut through lack of control.
Cutting of stone materials:
• It is best to use a diamond cutting
disc to cut stone materials. Make sure
in any case that the cutting disc is
suitable and labelled for your applica-
tion.
• When cutting stone materials, ensure
that the dust extraction is sufficient.
• Wear a dust protection mask.
• The device may only be used for dry
cutting/dry grinding.
Information on building statics:
Slits in structural walls are subject to the
standard DIN 1053 Part 1 or country-spe-
GB
35