Fax +1 305 430 9692
Do not immerse the motor block or base in water or any liquid or put
•
it in a dishwasher.
Do not use with wet hands.
•
Do not use cleaning products or detergents.
•
Only use with the adapter supplied or of the same type (Input: AC
•
110V 60Hz, Output: DC 9V 300mA)
TROUBLESHOOTING
If the mill does not grind, or if no motor noise can be heard, please
•
check that the batteries are not discharged. Recharge if necessary.
If batteries cannot be recharged, replace by new rechargeable
•
batteries (see: BEFORE USE).
If the light is faulty, please clean the electrical contacts on the spice
•
container and under the motor block.
If the mill gets stuck during use (motor produces hum, but internal
•
shaft does not turn and no pepper is ground], check the container is
properly installed, then gently shake the mill or tap the mill gently on
a hard surface, to remove the stuck pepper or salt.
To remove deeply stuck peppercorn, remove the upper lid as if for
•
re-filling the mill, turn the coarseness setting to its coarsest, and tap
lightly on a hard surface until all the peppercorn is released. Re-
adjust coarseness setting to the desired level once done and
replace upper lid.
Note: too fine of a grind setting may not enable salt or pepper to be
ground. If the case, set the grinder to a coarser setting (see above).
PROTECTION OF THE ENVIRONMENT
In order to preserve our environment and protect human health, the
waste electrical and electronic equipment should be disposed of in
accordance with specific rules with the implication of both suppliers
and users. For this reason, as indicated by the symbol
label or on the packaging, your appliance should not be disposed of as
unsorted municipal waste. The user has the right to bring it to a
municipal collection point performing waste recovery by means of
reuse, recycling or use for other applications in accordance with the
directive.
Copies of the I/B. Please reproduce them without any
changes
except
under
International USA. The pages must be reproduced and folded
in order to obtain a booklet A5 (+/- 148.5 mm width x 210 mm
height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't change
the page numbering. Keep the language integrity.
what is inside the frame.
6
Assembly page 6/24
special
instruction
from
Team
Print only
on the rating
PPG 40738 - 120501