Volvo V31664413-02 Manual Del Usuario página 15

– Screw the load carrier into place.
– Tighten the screws until the indicator
on the handle is opposite the two
markings. Then the correct tightening
torque of 6 Nm has been reached.
Caution!
Check that the load carriers are secure
by rocking them.
Removing load carriers
– Use the lug on the torque wrench or the
car's ignition key to detach and secure
the cover. Turn a 1/4 of a turn.
– Slacken off all screws.
– Press in the end (A) of the load carrier.
– Lift the load carriers up and out from
the rails.
Load carrier, rails EN
Installing load carrier with wing profile
13