Kohler Sterling Enclave Instrucciones De Instalación página 10

6. Install the Cleats
Cleat
Wall
Jamb
NOTICE: There is a left ("L") and right ("R") cleat. Position them inside the shower area.
Slide the cleat into the channel between the wall jamb and the wall.
NOTICE: The cleat should be level and flat against the wall.
Make sure the cleat sits flush against the top of the wall jamb.
Hold the cleat level and firmly in place and use it as a guide to drill two diagonally opposed 1/4" holes in the wall. For
example, top left and bottom right.
Remove the cleat and install the provided wall anchors. If necessary, gently tap the anchors to fully seat them against
the wall.
Repeat for the second cleat.
Thoroughly clean the shower base/bath floor, ledge, and wall.
NOTICE: The second set of holes can be used if the cleat is not level. Repeat the steps above, if needed.
Secure each cleat to the wall using two #8-18 x 1-1/2" screws.
Make sure the cleats are level. Loosen the screws and adjust the cleat position if needed.
1417143-2-B
10
8-18 x 1-1/2"
Sterling