12. Assemble the Inside Panel
10-24 x 1-1/4"
Tab Down
NOTICE: The inside panel roller mounting holes are 4-3/8" (111 mm) below the top of the panel.
NOTICE: The inside rollers contain a brass insert.
Position each roller on the same side of the panel as the label.
Install each inside roller with the tab down. This will position the door at its lowest setting.
Secure each roller with a #10-24 x 1-1/4" screw.
Using a hand screwdriver only, securely tighten the screws.
1417143-2-B
Clamp
4-3/8"
(111 mm)
Inside Roller
16
Brass Insert
Sterling