Vaisala MHT410 Guía Rápida página 14

2 Installation
Before you install the transmitter:
• Go through the check list in section
• Read this whole guide carefully.
CAUTION!
configured for MHT410. See
2.1 Recommended Installation Locations
The probe must always be installed in a valve. The correct thread of the valve is female 1.5"
NPT. Do not install the transmitter in a valve with a different thread. For example, the R thread
is incorrect. If you use a different thread than female 1.5" NPT, your equipment may be
damaged and the connection is not leak tight.
Figure 2 Recommended Installation Locations
8
Make sure the oil type of the transformer matches the oil type
Oil Type Information in Order Code (page
Planning the Installation (page
M211736EN-D
9).
6).