Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3. Make sure the bleed screw is closed. Fasten the mounting nut on the ball valve to finger-
tightness with your hand. Leave the bleed screw directly on top of the nut.
If you cannot position the bleed screw on top of the mounting nut by tightening just with
your hand, you can use a wrench (50 mm) to turn the mounting nut a maximum of a ½
turn.
CAUTION!
fastened it on the valve, you must remove the transmitter from the valve,
remove the PTFE tape, and start again from
4. With a 3 mm Allen key, loosen the bleed screw. Place a bucket under the mounting nut.
12
If you need to loosen the mounting nut after you have
step 2
with new PTFE tape.
OPEN
max. 3 × 360°
M211736EN-D
Publicidad
Tabla de contenido
