Rampage 8627 Instrucciones De Instalación página 2

3
Locate two factory holes on the front
driver side pinch weld. Attach the
Front Driver Side Mounting Bracket
to the pinch weld using the included
(2) 6-1.00mm x 25mm Allen Bolt, (2)
6mm Nylock Nut, and (4) 6mm Fender
Washers. Do not tighten at this time.
See Figure 3
4
For 2007-2011 models - Attach the Front
Driver Side Mounting Bracket to the
under side panel using the
included (1) 10mm x 35mm hex head
bolt (1) 10mm lock washer and (1) 10mm
flat washer. Do not tighten at this time.
For 2012-2018 models - Attached the
Front Driver Side Mounting Bracket to
the under sidepanel using the included
(1) 8mm x 35mm hex head bolt (1) 8mm
lock washer and (1) 8mm flat washer. Do
not tighten at this time.
See Figure 4
5
Repeat steps for Driver Rear.
NOTE: The rear brackets use only (1)
bolt at the pinch weld.
See Figure 5
Figure 3
Figure 4
2007-2011 models - (1) 10mm x 35mm
Hex Head Bolt, (1) 10mm Fender washer, &
(1) 10mm Lock Washer.
2012-2018 models - (1) 8mm x 35mm, (1) 8mm
Lock Washer, (1) 8mm Flat Washer.
Figure 5
Page 2 of 3