Care And Cleaning - Rampage 8627 Instrucciones De Instalación

6
Position Driver Nerf Bar onto brackets.
Attach Nerf Bar to Mounting Brackets
using the included (4) 8-1.25mm x 25mm
Hex Head Bolt, (4) 8mm Lock Washers,
and (4) 8mmFender Washers. Do not
tighten at this time.
See Figure 6
7
Level and adjust nerf bar and brackets, then tighten all hardware.
8
Repeat steps 1-7 on opposite side.

Care and Cleaning

• Rampage Steps are built to last; any detergent you use to wash your vehicle is sufficient to clean the steps.
Do not use any harsh abrasive detergents. Periodically check and lubricate moving parts, tire swing pivot has
a zerk fitting to grease joint.
Congratulations!
You have purchased one of the many quality Rampage branded products offered by Lund International. We take the
utmost pride in our products and want you to enjoy years of satisfaction from your investment. We have made every
effort to ensure that your product is top quality in terms of fit, durability, finish and ease of installation.
The material that your product is made from can
be recycled. Please also consider recycling the
packaging that your product came in.
800-328-2409• Visit us at Rampageproducts.com
© 2018 Lund Motion Products, Inc. All rights reserved.
Rampage Products™ is a trademark of Lund Motion Products, Inc.
Page 3 of 3
Figure 6