Sanus VISIONMOUNT VM400 Instrucciones De Montaje página 11

Wall Mounting
For assistance in determining wall plate location, see Height Finder at sanus.com.
Wood Stud Mounting
1. Locate stud. Verify the center of the stud with an awl or thin nail or use
an edge to edge stud fi nder.
2. Level the wall plate [01] and mark the hole locations.
3. Drill pilot holes as illustrated.
4. Tighten the lag bolts [22] only until the washers [21] are pulled fi rmly
against the wall plate [01].
CAUTION:
Improper use could reduce the holding power of the lag
bolt. To avoid potential injuries or property damage:

Pilot holes MUST be drilled to a depth of 63.5 mm (2.5 in.), using a 5.5
mm (7/32 in.) diameter drill bit.

Do not over-tighten the lag bolts [22].

Any material covering the wall must not exceed 16 mm (5/8 in.).
1
< 16 mm
(5/8 in.)
2
[01]
6901-002103 <00>
13 mm
5.5 mm
(1/2 in.)
(7/32 in.)
CAUTION:
3
4
[01]
[21]
[22]
3
63.5 mm
(2.5 in.)
11