Craftsman 139.53965SRT Manual Del Propietário página 12

Abridor de puerta de cochera
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION
STEP
1
Determine
the
Header
Bracket
Location
To prevent possible SERIOUSINJURYor DEATH:
• Header bracket MUST be RIGIDLYfastened to
structural support on header wall or ceiling, otherwise
garage door might not reverse when required. DO NOT
install header bracket over drywall.
• Concreteanchors MUST be used if mounting header
bracket or 2x4 into masonry.
• NEVERtry to loosen, move or adjust garage door,
springs, cables, pulleys, brackets, or their hardware, all
of which are under EXTREMEtension.
• ALWAYScall a trained door systems technician if
garage door binds, sticks, or is out of balance. An
unbalancedgarage door might not reverse when
required.
Vertical
Centerline
Finished
Ceiling
2x4
Structural
Supports
Installation procedures vary according to garage door
types. Follow the instructions which apply to your
door.
SECTIONAL
DOOR
AND ONE-PIECE
DOOR WITH TRACK
1. Close the door and mark the inside vertical
centerline of the garage door.
2. Extend the line onto the header wall above the
door.
You can fasten the header bracket within 4 feet of
the left or right of the door center only if a
torsion
spring or center bearing plate is in the
way; or you can attach it to the ceiling
(see
page 14) when clearance is minimal.
(It may be
mounted
on the wall upside down if necessary,
to
gain approximately
1/2").
If you need to install the header bracket on a 2x4
(on wall or ceiling), use lag screws (not provided)
to securely fasten the 2x4 to structural supports as
shown here and on page 13. If installing into
masonry, use concrete anchors (not provided).
3. Open your door to the highest point of travel as
shown. Draw an intersecting horizontal line on the
header wall 3" above the high point. This height
will provide travel clearance for the top edge of the
door.
NOTE: Door clearance brackets are available for
sectional doors when headroom clearance is less
than 3". See accessory page 38.
Proceed to Step 2, page 14.
Ceiling
Header Wall
i--
3"
Track
S I
Highest Point
of Travel
Door
Sectional door
with curved track
One-piece door
with horizontal
track
Header Wal_
Track
:
3"
Highest
Point
of Travel
;y
7
12

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido