Assemble The Rail - Craftsman 139.53965SRT Manual Del Propietário

ASSEMBLY STEP 1
Assemble the Rail
To avoid installation difficulties, do not run the
garage door opener until instructed to do so.
1. Turn the opened rail carton upside down, emptying
its contents onto a level work surface.
2. Unfold the rails, taking care to avoid kinking the
screw rod joint.
3. Rotate the rail sections so that the flat side is down
and the screw side is up. Keep it clean and free of
debris while you are working.
Rail
Support
Braces
Straight
Door Arm
Sprocket
End Remove
Cardboard Packing
Door
End
Rail Assembly
Carton
Remove
Cardboard Packing
Rail Assembly Chassis Assembly
Hardware Bag Hardware Bag
NOTE: During assembly, avoid pulling the rail section _ Sprocket End
housing the trolley rack away from the screw rod. f "_
The rack is factory set about 9" from the end of the
Rotate _
screw rod to the center of the rack. _ __
If the plastic liner slides part way out during __
assembly, simply push it back in.
Door End