Craftsman 139.53965SRT Manual Del Propietário página 17

Abridor de puerta de cochera
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLING THE BRACKETS
Be sure power to the opener is disconnected.
Install and align the brackets so the sensors will face
each other across the garage door, with the beam no
higher than 6" above the floor. They may be installed
in one of three ways, as follows.
Garage door track installation
(preferred):
• Slip the curved arms over the rounded edge of
each door track, with the curved arms facing the
door. Snap into place against the side of the track.
It should lie flush, with the lip hugging the back
edge of the track, as shown in Figure 1.
If your door track will not support the bracket
securely, wall installation is recommended.
Wall installation:
• Place the bracket against the wall with curved arms
facing the door. Be sure there is enough clearance
for the sensor beam to be unobstructed.
• If additional depth is needed, an extension bracket
(see Accessories) or wood blocks can be used.
• Use bracket mounting holes as a template to locate
and drill (2) 3/16" diameter pilot holes on the wall at
each side of the door, no higher than 6" above the
floor.
• Attach brackets to wall with lag screws
(not provided).
• If using extension brackets or wood blocks, adjust
right and left assemblies to the same distance out
from the mounting surface. Make sure all door
hardware obstructions are cleared.
Floor installation:
• Use wood blocks or extension brackets (see
Accessories) to elevate sensor brackets so the
lenses will be no higher than 6" above the floor.
• Carefully measure and place right and left
assemblies at the same distance out from the wall.
Be sure all door hardware obstructions are cleared.
• Fasten to the floor with concrete anchors as shown.
Figure
1
DOOR TRACK MOUNT (RIGHT SIDE)
k_
oor
Track
\
Indicator
Light
Figure 2
(Provided
with
Extension
F__,_'"
Bracket)
WALL MOUNT (RIGHT SIDE)
ex,en
on
Bracket
(See Accessories)
I.,,n
(Provided
with
.J__J
Extension
Bracket)
i:__. -;_
__
Sensor
_t___
- Bracket
I
Indicator
Lens
Light
Figure
3
FLOOR MOUNT (RIGHT SIDE)
Lens
Sensor
Bracket
Extension
Bracket)
Indicator
Light
(Provided
with
Extension
Bracket)
{_
_L_
_totanC_e_VitAh
nc ho rs
I _
_
(nOt prOvided)
r_ _/
Exte?ston
_
[ f
_
_racKeT
ssories)
17

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido