Install The Lights And Lens; Attach The Emergency Release Rope And Handle - Craftsman 139.53965SRT Manual Del Propietário

INSTALLATION STEP 10
Install the Lights and Lens
• Install a 100 watt maximum light bulb in each
socket. The lights will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the lights will turn OFF.
• Insert bottom lens tabs into slots on chassis and
tilt towards chassis to engage top tabs, then drop
down gently into place. (See illustration.)
• To remove, lift lens up and gently tilt slightly
outward and down, then pull out to clear bulbs.
Use care to avoid snapping off bottom lens tabs.
• Use standard neck Garage Door Opener bulbs for
replacement.
Top Lens Tab
Lens
Bottom
Chassis Slots
I [!1 o(
Top
O__ 0 © O 0 _ \ I
', Lens Tab
Chass,sS,ot ) 2./
Bottom Insert Bottom
Chassis Slot Lens Tabs First
INSTALLATION STEP 11
Attach the Emergency Release
Rope and Handle
• Thread one end of the rope through the hole in the
top of the red handle so "NOTICE" reads right side
up as shown. Secure with an overhand knot at
least 1" from the end of the rope to prevent
slipping.
• Thread the other end of the rope through the hole
in the release arm of the outer trolley.
• Adjust rope length so the handle is 6 feet above
the floor. Secure with an overhand knot.
NOTE: If it is necessary to cut the rope, heat seal
the cut end with a match or lighter to prevent
unraveling.
• To prevent possible SERIOUSINJURYor DEATHfrom
a falling garage door:
- If possible, use emergency releasehandle to
disengage trolley ONLYwhen garage door is
CLOSED.Weak or broken springs or unbalanced
door could result in an open door falling rapidly
and/or unexpectedly.
- NEVERuse emergency releasehandle unless garage
doorway is clear of persons and obstructions.
• NEVERuse handle to pull door open or closed. If rope
knot becomes untied, you could fall.
Trolley
I
o LI °o+
ro,,e
Release Arm _ /
_'_, Overhand
Emergency _ -"_M/Knot
Release Handle _
23