Stopping Engine; Connecting Electrical Loads - Porter Cable BSV550-W Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STOPPING ENGINE

1.
Disconnect all electrical loads.
2.
Turn ON/OFF switch to "OFF" po si tion.
3.
Close fuel shut-off valve.

CONNECTING ELECTRICAL LOADS

1.
Let engine run and warm up for five minutes after starting with no electrical
load.
Connect loads in the following manner to prevent damage to equipment:
2.
Connect inductive load equipment first, inductive loads consist of
refrigerators, freezers, water pumps, air conditioners, or small hand tools.
Con nect the items that require the most watt age first. See Wattage Cal cu la-
tion Section in this man u al.
3.
Connect the lights next.
4.
Voltage sensitive equipment should be the last equipment connected to
the generator. Plug voltage sensitive appliances such at TV's, VCR's, mi cro-
waves, ovens, computers, and cordless telephones into a UL listed voltage
surge protector, then con nect the UL listed voltage surge protector to the
generator.
on your generator.
Follow the wattage calculation table in the Wattage Calculation section of
this manual. Overloading the generator will cause power fluctuations and
can damage equipment and appliances.
Porter-Cable Corporation will only be responsible for damage to customer's
equipment when the generator is determined to be defective. This
determination will only be made by an authorized representative of Porter-
Cable Corporation and this decision will be final. Porter-Cable Corporation
reserves the right to inspect the electrical connections at the customer's
site of operation and test the generator for proper operation before any
determination of liability is made. Failure to maintain the equipment or
wiring for inspection will void any claim for damages by the customer.
Porter-Cable Corporation will not be responsible for equipment damaged as
a result of voltage surges, improper operation or improper installation of the
generator.
A16596
Failure to connect and operate equipment in this sequence
can cause damage to equipment and will void the warranty
14- ENG

Publicidad

Tabla de contenido
loading

Tabla de contenido