Safety; Intended Use - Fronius MTG 2500 S Manual De Instrucciones

Safety

Safety
Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
▶
▶
Danger from electrical current.
This can result in serious personal injury and damage to property.
▶
▶
Danger from electric current due to defective system components and incorrect
operation.
This can result in serious personal injury and damage to property.
▶
▶
Danger due to hot system components and/or equipment.
This can result in serious burns or scalding.
▶
▶
Danger from contact with toxic welding fumes.
Serious personal injuries may result.
▶
▶
▶

Intended use

The MIG/MAG manual welding torch is intended solely for MIG/MAG welding in manual
applications.
26
WARNING!
All the work and functions described in this document must only be carried out by
technically trained and qualified personnel.
Read and understand this document in full.
Read and understand all safety rules and user documentation for this equipment
and all system components.
WARNING!
Before starting work, switch off all devices and components involved, and discon-
nect them from the grid.
Secure all devices and components involved so they cannot be switched back on.
WARNING!
All cables, leads, and hosepacks must always be securely connected, undamaged,
and correctly insulated.
Only use adequately dimensioned cables, leads, and hosepacks.
WARNING!
Before starting work, allow all hot system components and/or equipment to cool to
+25°C/+77°F (e.g., coolant, water-cooled system components, wirefeeder drive mo-
tor, etc.).
Wear suitable protective equipment (e.g., heat-resistant gloves, safety goggles, etc.)
if cooling down is not possible.
WARNING!
Always extract welding fumes.
Ensure that there is a sufficient supply of fresh air. Ensure that there is a ventilation
flow rate of at least 20 m³ (169,070.1 US gi) per hour at all times.
In case of doubt, the concentration of noxious substances at the work station should
be assessed by a safety engineer.