Electrical Connection - Trigano 880 237 Manual De Instalación Y Mantenimiento

INSTRUCTIONS FOR ASSEMBLING AND USING
THE SKIMMER
Read carefully this manual before installing the apparatus and follow all the instructions.
Keep this manual for future consultations regarding the functioning of the Skimmer.

Everything regarding electrical input must be referred to the regulations: NF C
15-100 / EN 60-335-2-41 / EN 60-335-2-55 / CEI 64-8
Or to the analogous regulations in force in each zone or country.

All the filters follow the installation regulation NF C 15-100, concerning that each electrical
apparatus placed less than 3,5 m from the edge of the pool and easily accessible must be
supplied in low tension 12 volts.

Do not operate the apparatus while the pool is being used.

Do not operate the apparatus without water.

Always disconnect the electrical input tap when the apparatus must be handled.

The cable of the pump must be connected to a 30mA differential switch.

Never use the apparatus for more than 5 consecutive hours.

If the flexible power supply cable of the apparatus is damaged, it should be replaced. Read
instructions how to replace it carefully. If in doubt, consult your technical service.
1. INSTALLATION
This equipment (Fig.1) is easy to install and can be assembled by AN ADULT in around ½
HOUR, taking care to correctly follow the instructions detailed in this manual at all times. The
purifier must be installed downwind from the prevailing breezes (Fig.2). The filtering system is
mounted on the edge of the pool by means of the mounting bracket (Fig.3 and 4). The purifier
must be placed in the pool so that the float is at pool water level (Fig.4) (the mounting bracket
may be adjusted by means of the adjustment handle as shown in figure 9). The water level
should be checked visually on a regular basis.
Balance the apparatus so that it is level on the vertical plane (Fig.6).

2. ELECTRICAL CONNECTION

Everything regarding the electrical connection must be in observance of the regulations:
Referred to "the construction of electrical connections both in indoor and outdoor swimming
pools", or to the analogous regulations in force in each zone or country. The transformer must
be placed at least 3,5 meters away from the pool, in accordance with the NF C15-100. The
purifier's electrical cable cannot be replaced. If the cable is damaged, the entire device must be
discarded and replaced.
®
FILTER
NF C15-100
3 Notice N°880237