Stove Operation; Starting The Stove; Modifying The Parameters; Switching Off - Palazzetti 14060 Uso Y Funciones

3 STOVE OPERATION

3.1 STARTING THE STOVE

Before every ignition, be sure that burning pot is completely empty and properly positioned in its seat.
To start the stove hold the
Automatic stove ignition: the stove comes with an automatic device that starts the pellet stove without using other
or drying of certain materials used. This phenomenon will gradually disappear.

3.2 MODIFYING THE PARAMETERS

power supply.

3.3 SWITCHING OFF

To switch the stove off hold the
To start the stove again it's recommended to wait for the stove to cool down completely.
The stove should only be switched off following the procedure described above. Never switch the stove off by
unplugging it from the power supply.

3.4 OPERATION WITH ROOM THERMOSTAT

output (that is, the stove attempts to maintain the desired temperature while minimising fuel consumption) when
reaching the set water temperature.
thermostat (circuit closed).
The stove will go off automatically even in the case the water temperature keeps growing notwithstanding the modulation

3.5 OPERATION WITH ROOM PROBE ON THE BOILER

on the boiler (that is, the boiler attempts to maintain the desired temperature while minimising fuel consumption).
The desired room temperature can be set in temperature menu
[6]
of the setup menu

3.6 OPERATION IN COMBINATION WITH A STORAGE TANK

whether the storage tank is with or without a coil inside.
The boiler is controlled based on the temperature read by the probe in the storage tank.
When reaching the storage tank temperature set in the temperature menu
button for several seconds.
can be used to set the desired water outlet temperature (the best temperature
[7]
of the setup menu
[7]
of the setup menu
.
[8]
of the setup menu
.
.
21