Trouble-Shooting - Brill 380 ASM Manual Del Usuario

If you interrupt your work to
move to another working area,
always switch off your Accu
Hand Lawnmower and pull the
GB
PowerAccu out of the contact
bar.
A
Check the environment
Never use the unit when it is
raining or in damp or wet areas.
Do not operate your Accu Hand
Lawnmower near swimming
pools or garden ponds.
Please observe the prescribed
local quiet times.
Keep the charger in a dry place.
Notes on safety regard-
A
ing the PowerAccu /
Danger of fire

11. Trouble-shooting

The following table contains the problems most frequently occurring and shows how to remedy them.
Problem
Abnormal noise.
Clattering in the unit.
Metal-like hammering noises.
Motor will not start.
Motor turns off.
26
Never charge the Accu after
having been heated up by oper-
ation or sun. Let cool down
first.
Never expose the Accu to direct
sunlight while charging.
Never charge the PowerAccu
when connected to a 24-Volt
tool.
Never charge the Accu anywhere
near acids and easily inflamm-
able materials. Danger of fire !
Only use the PowerAccu with
the specified tools.
Under extreme conditions, some
accu acid could escape. This,
however, does not represent a
defect. Proceed as follows should
the casing leak :
Possible cause
Motor fixing screws or
mower casing loose.
Foreign body blocking the
cutting cylinder.
PowerAccu not pushed all the
way in.
Circuit breaker has been
triggered.
Blocked by foreign body.
Blocking protection activated.
The cutting height you have
selected is too low; you are
pushing the mower too quickly.
Circuit breaker has been
activated.
1. Immediately wash the
affected area of the skin
with soap and water.
2. Neutralize the accu acid
with vinegar or lemon
juice.
3. If accu acid should get into
your eyes, rinse your eyes
for at least 10 minutes with
fresh water. Then contact your
doctor immediately !
Do not throw the used Accu into
fire under any circumstances.
Danger of fire !
Contacts should never be
bridged with metal or other
electric conducting parts.
Short-circuit – fire risk !
Remedy
Tighten screws.
Turn off the mower. Pull the
PowerAccu out of the contact
bar. Remove the foreign body.
Harness is not flat against
PowerAccu.
Wait approx. 2 - 5 minutes then
turn on the motor again.
Switch off the motor. Pull the
PowerAccu out of the contact
bar. Remove the foreign body.
Let the motor cool for 2 - 5 min-
utes, then use the mower with a
higher cutting height and reduce
the cutting height in stages until
you reach the lower cutting height
you require. Push the mower
more slowly across the lawn.