Num'axes CANICOM 300+ Manual De Instrucciones página 15

3. First use from new
3.1. Fitting the battery in the CANICOM receiver collar
-
Unscrew the 4 screws of the top of CANICOM using a screwdriver.
-
Insert the battery (3 Volt Lithium CR 2) paying attention to follow polarity indicated on the battery housing.
-
A beep sound is emitted indicating the correct installation of the battery. If you do not hear any beep sound
after inserting the battery, immediately remove it from its housing. Check the polarity before trying again.
-
Before putting the lid back in place, check that the rubber seal is in its groove.
-
Retighten moderately the 4 screws.
Polarity "-" of the battery
3.2. Activate/deactivate the remote control
The remote control is supplied with battery fitted.
- Activate: press for 1 second the On/Off red button
appear on the LCD screen.
- Deactivate: press for 1 second the On/Off red button
screen switches off.
To increase the remote control battery life, you should deactivate it if you are not using it for a long period.
3.3. Activate/deactivate the CANICOM training collar
A magnet located in the remote control allows you to switch ON or OFF the CANICOM receiver collar.
- Activate: move the remote control towards the collar so that the magnet position indicator on the remote
control comes into contact with the red mark on the collar, hold for 1 second. The indicator light on the collar
will flash in green indicating the CANICOM collar is ON.
- Deactivate: move the remote control towards the collar so that the magnet position indicator on the remote
control comes into contact with the red mark on the collar, hold for 1 second. The indicator light on the collar
will flash from green to red and then off: the CANICOM collar is OFF.
To increase the collar battery life, you should deactivate it if you are not using it for a long period.
Guide CANICOM 300+ - indice A – Mars 2020
Polarity "+" of the battery
located on the side of the remote control. Indications
Activate/deactivate
the receiver collar
Approach until coming into contact
those two areas for 1 second.
located on the side of the remote control. The LCD
Rubber seal
15/52