Craftsman CMXGZBF71243311 Manual De Instrucciones página 9

Step 15: (fig. 15)
1. Place a large washer (38), short spacer tube (41), and the
drive disk (8) onto the shaft. Fit the short spacer tube
and large washer onto the flanged bearing in the end
plate. See figure 15.
Fig. 15
8
Step 16: (fig. 16)
1. Place two spike disks (7), separated by a long spacer
tube (20), onto the shaft. Fit the long spacer tube onto
the ends of the flanged bearings in the disks. See figure
16.
Fig. 16
20
7
Step 17: (fig. 17)
1. Place a 5/8" flat washer (33), the compression spring
Fig. 17
41 38
Step 18: (fig. 18)
1. Place two spike disks (7), separated by a long spacer
Fig. 18
(49) and another 5/8" flat washer (33) onto the shaft.
See figure 17.
33
tube (20), onto the shaft. Fit the long spacer tube onto
the ends of the flanged bearings in the disks. See figure
18.
20
7
ENglISh
49
7