Error Messages; Service Procedures - Icare TA01i Manual De Usuario Y Mantenimiento

Error messages

To clear error messages, press the measurement button, after which the measurement can be repeated.
The following messages may appear:
• bAtt ........................... The batteries are low. Replace the batteries
• E 01 ........................... The probe did not move at all.
If this error message is repeated, turn the tonometer so that the collar faces down for a short time.
If the error message is repeated, remove the probe base and replace it with new ones
(see page 9).
• E 02 .............................The probe did not touch the eye.
The measurement was taken from too far away.
• E 03 ..............................The probe speed was too low.
The measurement was taken from too far away or the tonometer was tilted too far upwards.
• E 04 ..............................The probe speed was too high.
The tonometer was probably tilted downwards. Make sure that the central groove is in the
horizontal position.
• E 05 ...............................The contact with the eye was too "soft. "
The probe probably made contact with the eyelid.
• E 06 ................................The contact with the eye was too "hard. "
The probe made contact with the opening eyelid or calcification in the cornea.
• E 07 ................................ " Bad hit. "
The probe measurement signal detected by the tonometer was unusual. The probe may have
made contact with a peripheral part of the cornea or the probe was twisted or otherwise inserted
incorrectly. If this error message repeats, remove and replace the probe.
• E 09 ................................ " Bad data. "
An erroneous measurement for a reason other than those described in E01−E07.

Service procedures

• Replace the batteries when the <bAtt> message appears.
• Change the probe base if the probe does not move smoothly.
• No other service procedures can be carried out by the user. All other servicing and
repairs must be carried out by the manufacturer or certified service facilities.
• The device can be cleaned with a damp cloth containing disinfectant.
10