Maintaining The Brushroll; Maintaining The Soft Roller; Checking For Blockages - Shark DuoClean Flexology HV390EU Serie Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 20
MAINTAINING YOUR VACUUM - CONT�
WARNING: To reduce
the risk of shock and
unintended operation,
turn off power and
unplug unit before
servicing.
WARNING: When
cleaning brushroll,
be sure to not cut
anything other than
hair, string, fibres, or
other debris.
TIP: If nozzle
headlights are
flashing, then the
brushroll garage is not
completely closed.
Ensure the garage is
completely closed by
pressing down firmly
on both sides.
NOTE: Heavy usage over
time may require minimal

MAINTAINING THE BRUSHROLL

upkeep to maintain your
Open the brushroll lid by sliding both release
1
vacuum's appearance.
buttons away from you, toward the back of the
nozzle, then lifting off the lid. Remove any string,
hair, or debris that may be wrapped around the
brushroll by running scissors along the guide on the
brushroll.
2 Press down on both sides of the lid until it clicks into
place.
15
STEP 1
STEP 2

MAINTAINING THE SOFT ROLLER

1
Open the brushroll by sliding both
release buttons away from you, toward
the back of the nozzle, then lifting off
the lid. Lift out the Soft Roller by the
tab on the right side. Clean off any
string, carpet fibres, or hair that may
be wrapped around the Soft Roller.
Remove debris from the roller housing.
2 Wash the Soft Roller as needed, using
only water. Air-dry completely for at
least 24 hours before returning it to the
brushroll garage.
3 Reinsert the Soft Roller by sliding it
into the front of the nozzle until it
clicks into place. Close the brushroll
garage by inserting the tabs on the
lid into the slots, then pressing down
on both sides of the lid until it clicks
into place.

CHECKING FOR BLOCKAGES:

HANDHELD, WAND, AND FLOOR NOZZLE
1
Remove the wand from the handheld
vacuum and check all intake
openings on the dust cup.
2
Remove the floor nozzle from the
wand and check the wand for
blockages.
3
Tilt neck of floor nozzle back to
straighten the airway, then remove
blockages.
s h a r kc l e a n . e u
16

Publicidad

Tabla de contenido
loading

Tabla de contenido