Far Tools CM 250 Manual De Instrucciones página 24

Don't use too small section woodpiece, it must be dangerous for the operator. use suitable tools with a defi-
ned thickness of the chip for manual feeding.
While working , feed the workpiece firmly and evenly along the guide ruler, and if possible, the position of
your hands must prevent the workpiece from being held along its whole perimeter.
following knives used It is possible to realize all sorts of shaping with this machine.
In case of you are working on big woodpieces, make sure they are the adapted support. For example you can
use roller stand type «111510,111505 or 111500» .
push your woodpiece in the opposite way as the rotation direction of the tool.
Use pression bars conjointly with the protectors. please use all thrusts ( face and/or back) delivered For pre-
vent all injury on your person caused by an eventual kickback of the machine.
113752-Manuel-A-EN .indd 24
Pression
bars
10/04/07 16:11:40