Mechanical Cleaning/Disinfecting - B.Braun Aesculap GA553 Instrucciones De Manejo/Descripción Técnica

Aesculap
Pneumatic motor GA553
Phase I
►
Clean the product under running faucet water, using a suitable clean-
ing brush until all visible residues have been removed from the sur-
faces.
►
Mobilize non-rigid components, such as set screws, links, etc. during
cleaning.
Phase II
►
Dry the product in the drying phase with suitable equipment (e.g. cloth,
compressed air), see Validated cleaning and disinfection procedure.
6.8

Mechanical cleaning/disinfecting

Note
The cleaning and disinfection device must be of tested and approved effec-
tiveness (e.g. FDA approval or CE mark according to DIN EN ISO 15883).
Mechanical alkaline cleaning and thermal disinfecting
Machine type: single-chamber cleaning/disinfection device without ultrasound
Phase Step
I Prerinse
II Cleaning
III Intermediate rinse
IV Thermal disinfecting
V Drying
D–W: Drinking water
FD–W: Fully desalinated water (demineralized, low microbiological contamination: drinking water quality at least)
*Recommended: BBraun Helimatic Cleaner alkaline
►
Check visible surfaces for residues after mechanical cleaning/disinfect-
ing.
8
®
T t Water
[°C/°F] [min] quality
<25/77 3 D–W
55/131 10 FD-W
>10/50 1 FD-W
90/194 5 FD-W
- - -
Phase III
►
Wipe all surfaces of the product with a single-use disinfectant wipe.
Phase IV
►
After the specified exposure time (at least 1 min), rinse the disinfected
surfaces under running FD water.
►
Drain any remaining water fully.
Phase V
►
Dry the product in the drying phase with suitable equipment (e.g. cloth,
compressed air), see Validated cleaning and disinfection procedure.
Note
The cleaning and disinfection device used for processing must be serviced
and checked at regular intervals.
Chemical/Note
-
■
Concentrate, alkaline:
– pH = 13
– <5 % anionic surfactant
■
0.5 % working solution
– pH = 11*
-
-
According to the program for cleaning and disinfection device