Storage And Cleaning; Environment Safety; Customer Service; Faqs / Troubleshooting - VITO PRO-POWER VILGE710 Manual De Instrucciones

5.4 - STORAGE AND CLEANING

Cleaning
After each use clean every compo-
nents of the sander. Rub the ma-
chine with a clean and damp cloth or
blow it with low pressure com-
pressed air.
A careful handling protects the ma-
chine and extends its lifespan.
Storage
Keep the sander in its original box,
inside a dry place and away from
children's reach.
The tool does not start:
 The power cable is not plugged it or there is as
electrical failure;
 The extension cord is too long or the cable is too
thin;
 The "ON/OFF" switch is damaged;
 The power supply is too low;
The tool is working irregularly on the surface:
 The material or the surface are too hard;
 Deformed sanding pad;
Excessive thinning of the material or surface:
 The rotation speed is too high;
 The sand paper grit is too thick;
The surface quality isn't the desired:
 Not appropriate sandpaper;
 The periods of drying have not been respected;
 High proportion of filler, soft bitumen;
 Initiating the rotation of the sanding disc with the
sanding pad over the working surface (stretch
marks formation);
 The sanding plate is inclined;

6. ENVIRONMENT SAFETY

you can dispose on local recycling
points.
According to the European Directive
2012/19 /EC on electrical and elec-
tronic equipment waste and its
transposition into national law,
power tools must be collected separ

8. FAQS / TROUBLESHOOTING

Problem - Cause
The packaging is made up of
recyclable materials, which
Never place power tools in
the domestic waste.
 Check the plug, socket and circuit breaker of the
supply circuit;
 Remove or replace the extension.
Connect the power cord to the wall outlet;
 Replace the "ON/OFF" switch;
 Check if the power supply is suitable;

 Reduce the rotation speed;
 Replace the sanding pad;
 Reduce the rotation speed;
 Use a thinner sandpaper grit;
 Use a thinner sandpaper grit;
 Respect the drying periods and the manufacturer's
recommendations;
 Use a thinner sandpaper grit;
 Place the sanding pad on the surface with the disc
in rotation;
 Work with the sanding plate parallel to the working
surface;
32
ately and delivered to the collection
sites provided for this purpose.
You can obtain information regard-
ing the disposal of the machine
through the person in charge for the
recycling in your city.

7. CUSTOMER SERVICE

Tel.: 256 331 080
E-mail: sat@centrallobao.pt
Site: www.centrallobao.pt
Solution