Application Area; Safety Information; Liability Exclusion - Renfert Basic mobil Manual Del Usuario

ENGLISH
1. Introduction
We are pleased with your decision to purchase the
Basic mobil. The mobile sandblasting unit is connect-
ed to the compressed air or to the recyclable blaster
Vario-Jet risp. Vario basic .

2. Application Area

The Basic line of sandblasting units are designed
for use in dental laboratories to remove investment
residues, oxides on cast objects, and for surface
treatment.

3. Safety Information

• Always disconnect the unit from the com-
pressed air and power sources prior to begin-
ning any maintenance work.
• When working on the tank (filling up, clean-
ing, maintenance) wear protective glasses for
protecting your eyes.
• Any residue of abrasive material on the gas-
ket may lead to leakage and early wear of the
gasket. After filling up clean the thread and the
gasket and close the lid properly.
• Solvents and tensides can create micro-crack-
ing in the plastic (danger of explosion!). Clean
the tank and the lid only with a dry cloth. Do
not write or stick something on the tanks.
• Check the tanks and the lids regularly on dam-
ages and replace them in case of doubt.
• Check the tank cover for correct seating prior
to beginning operation. Covers that are not se-
curely closed can suddenly be blown off as the
tank pressure increases. The resulting flying
parts and abrasive represent a serious hazard.
• Never operate the blasting units without suit-
able dust extraction and appropriate protective
gear, as this could result in health hazards. The
type of dust extraction should be selected on
the basis of the dust being generated. Follow
here absolutely EN 60335-2-69 appendix AA or
ask the appropriate authorities.
• Improper use can result in the risk of eye or
skin injuries.
• Never direct the blasting material towards eyes
or unprotected areas of skin!
Basic mobil
No. 2914
• Do not employ the foot switch when only the
compressed air supply hose is connected. The
loose hose could wrap around itself and cause
serious injury.
• Only spare parts and accessories supplied or
authorized by Renfert GmbH may be used with
this product. If other spare parts or accessories
are used, this could have a detrimental effect
on the safety of the device, increase the risk of
serious injury and lead to damage to the envi-
ronment or the device itself.
• It is the responsibility of the operator that na-
tional regulations during operation and regard-
ing a repeated safety inspection of electrical
equipment are complied with. For Germany
these are the regulation 3 by DGUV (German
Statutory Accident Insurance) in relation with
VDE 0701-0702 (Association for Electrical &
Electronic Technology).
• Information on REACH and SVHC is available
on our website www.renfert.com, in the Sup-
port area.

3.1 Liability Exclusion

Renfert GmbH shall be absolved from all claims
for damages or warranty if:
• The product is employed for any purposes
other than those cited in the operating instruc-
tions;
• The product is altered in any way other than
those alterations described in the operating
instructions;
• The product is repaired by other than an autho-
rized facility or if any but Renfert OEM parts are
employed;
• The product continues to be employed, despite
obvious safety faults;
• The product is subjected to mechanical jarring
or is dropped.
Caution: Failure to wear proper eye
protection can result in eye injury due
to particles suspended in the air. Always
wear proper eye protection to protect
your vision!
EN