ISC RP290 Manual De Instrucciones página 11

[F] Use
1. Ensure that the working line is threaded correctly through the device
2. The tail end of the line can be pulled to remove slack. Further pulling of the tail end
will result in tension being applied in an upwards direction on the section that is to be
cut. This is useful when cut sections are to be lifted away from targets
3. For tensioning / lifting operations, the Wrench element of the Rigging Rope Wrench
will fold into a neutral position. On the RP292 120kg model, the one-way bearing will
rotate to reduce friction on the lift
4. For lowering operations, the Wrench element of the Rigging Rope Wrench will engage
and apply friction to the working end of the line. On the RP292 120kg model, the one-
way bearing will lock the pulley sheave and add extra friction to the working line
5. WARNING - The Rigging Rope Wrench is only designed as a friction aid. The user
must keep control of the tail end of the rope at all times during lowering operations
6. The user must wear gloves when handling and controlling the working line
7. ISC recommend the use of a 13mm (1/2") 12 Braid rope sling in either a Loopie or
Dead Eye configuration. Best practice dictates that the anchor sling should be double the
strength of the intended working line
[G] Installation
1. Open top pin and install anchor sling
2. Ensure anchor sling is compliant with the desired task and ensure a rope diameter
of no more than 13mm
3. Carefully begin to install the working rope through both sections of the device using
the markings as a guideline
4. Ensure the device has been prepared and installed correctly
[H] Applications
The device has been designed and manufactured for tasks involving the lowering of
material from trees used by arborists. It is to be operated by a minimum of 2 people,
including the individual working at height. The device has been tested to withstand
a maximum weight of 70kg (RP290), and 120kg (RP292). The device has not been
designed as PPE equipment and should not be used as such
CS Český
[A] Pojmenování součástí
1. Zamykací čep
2. Logo ISC
3. Varianta modelu
4. Maximální zatížení ložiska (RP290 70 kg, RP292 120 kg)
5. Kolečko (kluzné ložisko RP290, uzamykatelné ložisko RP292)
6. Sériové číslo
7. Spojovací článek (RP290 černý, RP292 šedivý)
8. Bočnice
9. Směr založení
10. Západkový čep
11. Maximální průměr lana
11
RP29X Rigging Rope Wrench: Issue A - March 2019