USING THE APPLIANCE
• Place the pulp collector (E) on the body of the appliance (see
• Place the filter (D) in the pulp collector (E). Ensure that the filter is
properly clipped onto the drive shaft (H) (see
• Fit the cover (C) on top of the pulp collector (E) and turn to lock the lid
(see
Fig.
4).
• Push the locking handle (G) to the rear until it locks into place. You will
hear an audible "click" (see
• Slide the pusher (A) into the feeding tube (B) aligning the groove on the
pusher with the small ridge in the feed tube (see
• Place the juice jug (M) under the pouring spout in front of the appliance
(see
Fig.
7).
• Plug in the appliance.
• To start the appliance, use the control dial (J).
• Insert the fruits or vegetables through the feeding tube (B).
• The fruits and vegetables must be inserted only while the motor is
running.
• Do not press too hard on the pusher (A). Do not use any other utensil.
NEVER push with your fingers.
• When you have finished, stop the appliance by turning the control dial
(J) to 0 and wait until the filter (D) stops completely.
• When the pulp collector (E) is full, or the juice flow slows down, empty
the pulp collector and clean the sieve and the cover.
• Remove the "pulp collector + filter" assembly by pulling vertically
using both hands (see
Fig.
5).
Fig. 9 and
10).
Fig.
3).
Fig.
6).
Fig.
2).
EN
57