Publicidad
Idiomas disponibles
Idiomas disponibles
28. The body harness is designed to connect at both
sides of the vehicle with a T-harness that will reach
up to the BCM. Locate the shorter section of the
body harness relative to the T-harness. Position the
two wire ends near the 48 way connector inside the
driver footwell.
29. Use a pry tool to remove the terminal locks from
the left and right sides of the 48 way connector.
30. Position the two wire ends near the back of the
connector. Insert the harness wiring as follows:
Brown wire into Pin 12
Red wire into Pin 13
Reinstall the terminal locks.
9/25/12
11
Publicidad
