Mirrored Glass Installation; Media Arrangement - Dimplex IGFIITEXL BOLD Guía De Instalación Y Uso

Installation

Mirrored Glass Installation

1. Attach the provided suction cup to the reflective
side of the mirrored glass. Ensure the suction cup is
securely attached.
2. Using the suction cup to assist, lift the mirrored glass
and place it into the bottom slot at an angle.
3. Tilt the mirrored glass into a vertical position.
(Figure 20)
4. Install the mirrored glass brackets to hold the glass in
place using the provided black screws. (Figure 21)
CAUTION: Ensure the mirrored glass does not fall
forward while the mirrored glass mounting brackets
are being installed.
5. Remove the suction cup and clean any fingerprints or
debris off the glass with a non-abrasive glass cleaner.
!
NOTE: Do not dispose of the suction cup! Keep it in a
secure location, as it may be needed for maintenance
and service on this fireplace.

Media Arrangement

For best results when using the supplied media, arrange
as follows:
1. Evenly disperse the small crystals to entirely cover the
media bed.
2. Place the driftwood pieces across the crystals.
3. Place the large and extra-large crystals as desired
over the smaller crystals and beside the driftwood.
It is possible to use custom media ornaments to decorate
your firebox. The custom media must fit easily without
scratching the glass or bowing the media bed, and must
not be composed of sand or liquid, which could interfere
with the safety of the firebox.
Figure 20
Figure 21
Mirrored Glass Bracket
Screws
Figure 22
17