Samsung SNC-C7478 Manual Del Usuario página 33

INITIal SeTuP VIa a
CrOSSOVer Cable
This section provides a guide on how to connect the IP
Smart Dome to your PC/laptop for initial setup.
Please follow the instructions in the order they appear,
without skipping steps. Do not supply power to the IP
Smart Dome, until instructed.
In order to access the IP Smart Dome's firmware you will
need to connect the IP Smart Dome Camera directly to a
PC or laptop computer via the supplied crossover cable.
1. Before you begin, you must determine the current
network/INTERNET (TCP/IP) settings on the PC
or laptop you plan to setup the IP Smart Dome.
Jot down your entries below for quick reference.
Current TCP/IP Settings
IP Address
Subnet Mask
Default Gateway
Primary DNS Server
Secondary DNS Server (Option)
2. In order for the IP Smart Dome to communicate
with your PC, you have to change your PC's IP
address and subnet mask
We recommend that you change your IP address to
192.168.1.11 and change the subnet mask to
255.255.255.0
Leave all other entries (Default Gateway, DNS Servers,
etc.) blank.
3. After you have made the changes to your IP
address and subnet mask, you may then attach
the IP Smart Dome to your PC via the supplied
crossover cable. Plug-in either end of the
crossover cable into the PC's network card and
the other end into your IP Smart Dome.
4. After connecting the PC and IP Smart Dome
using the crossover cable, power on the IP Smart
Dome by plugging in the power supply shipped
with the IP Smart Dome.
5. No longer than 1 minute after powering on the IP
Smart Dome, verify that the ACTIVE indicator light
is flashing, and the LINK indicator light is flickering
or solid.
Network Setup
6. Now you will be able to access the viewer
software within the IP Smart Dome.
Open Internet Explorer and type the IP address of
192.168.1.200 (default IP of the IP Smart Dome from
the factory) into the Address Bar of the web browser
(as seen below). Press Enter.
If a message appears after pressing "Enter" similar to
the image depicted below, choose "Try Again". This
message will vary depending on the operating system.
7. Now you will be able to see the login screen for
the IP Smart Dome.
8. The default ID is "root, default Password is
"4321". (without the "")
9. If at any time you are prompted to download
ActiveX controls, you must click 'Yes', all content
is safe.
You will have to click "Yes" twice to two individual
prompts. This allows your video to be displayed in
Internet Explorer.
English –