Samsung SNC-C7478 Manual Del Usuario página 47

Email(SMTP) or saved on the SDHC memory
card according to the <EVENT> ➝ <TRANSFER
SETUP> settings.
<Camera action>: Counteraction of camera
when Alarm Input event occurs can be selected
from <None>, <Preset 1 ~ 128>, <Pattern 1 ~
4>, <AutoPan 1 ~ 8>, <Scan 1 ~ 8>, <Home
Position>.
MOTION
M.D Function
❖
• Enable/Disable
M
Even though Motion Detection is set to be enabled, this
function is not working during PTZ, focus or Iris operations.
For reliable performance, it takes about 1 or 2 seconds for
Motion Detection to return to work after PTZ, Focus, Iris
operation.
Even if camera is subjected to external shocks or winds,
those can be considered as motion detection.
Motion Configuration
❖
• You can set motion detection performance
parameters.
Motion Sensitivity
❖
• Select a motion detection function sensitivity from
<High>, <Medium> and <Low>. The <High>
option provides high sensitivity of motion detection
and generates motion detection event if a small
motion is detected.
Motion area
❖
• You can set an area to detect motion.
activation Time
❖
• You can set time to accept a motion detection to
take an action.
<always>: Always conducts the <Action> setting
when a motion is detected.
Setup Tool
<Only Scheduled Time> : Conducts the <Action>
setting for a motion detection only when it occurs
during the specified time period on the specified
day of the week. The Start Time must prior to and
must differ from the End Time.
action
❖
• You can set an operation to be conducted when a
motion is detected.
<alarm Output> : Determines a motion detection
output port to which the alarm signal is to be sent.
<Output Duration>: Determines the period of time
to output the alarm signal to the specified alarm
output port when a motion is detected. If another
detection event is generated during the alarm
output, the delay time is recalculated on the basis
of the most recently generated motion detection.
<alarm Image Transfer>: If <On> is selected, a
JPG image is transmitted through FTP or Email
(SMTP) according to the <EVENT> ➝ <TRANSFER
SETUP> settings.
To set a motion detection target
area
You can set a specific area to detect a motion in.
1) In the MOTION window, click the [Motion Area]
button.
- The Motion Area window appears.
- You can set a specific area to detect a motion in.
2) Click over square boxes corresponding to your
desired motion detection target area.
- The selected area is colored in yellow.
3) To cancel a selection, click over the square box
once again.
- The square box returns to its original color.
4) To complete the setting, click the [Apply] button.
- The settings are saved.
- The motions in the selected area will be detected.
English – 7