KRESS Mission Nano KR101E Manual De Instrucciones página 15

Ocultar thumbs Ver también para Mission Nano KR101E:
Tabla de contenido

Publicidad

Battery charge error.
Error find home
timeout.
With the 'Lock
Function' enabled, if
your Mission
does not receive
a signal from your
Wi-Fi router for 3
days, then it gets
locked as a security
measure.
This could be
because your
router lost its power
or because you
changed your Wi-Fi
router or network
provider.
Module software
update failure
occurs.
Software update
failure occurs.
NOTES
• Before turning power on, always check Mission
• If for any reason—i.e. a party, children playing...—you want to park your Mission
base: press HOME then OK. Mission
will now wait until the next scheduled mowing session. If you want to re-start it at anytime, press START
then OK to start your Mission
• If an error repeatedly occurs in the same area of your lawn, you might have a problem with the boundary
wire so please refer to the installation instructions and check your set up is correct with its help.
• If your lawn is divided in two separated areas, connected by a corridor less than 1m wide, one of which
is not provided with the charging base: when Mission
charging base.
• If Mission
NANO runs abnormally once in a while, please reset it by turning it off and removing the battery
TM
for 30 seconds, then restart it. If the problem cannot be solved, please contact our Customer Service for
help.
1) Battery's temperature is too high (more than 550C) when charging.
Place the charging base in a shady area or wait until the temperature
has cooled down.
2) Battery's temperature is too low. The outside temperature doesn't
allow your Mission
time.
3) Poor connection: check the connection between the contact pins
located on the charging base and the charging strip and that the
charging base is on a perfect flat ground.
4) Power supply is broken: please contact Customer Services.
1) Charging base is badly placed (not on a flat ground),
Mission
NANO doesn't find pins and doesn't stop. Check the base.
TM
2) Mission
NANO runs out of battery before reaching the charging
TM
base. The extended boundary wire should not exceed 350 meters.
NANO
TM
Please reconnect Mission
originally paired with.
If this is not possible, contact Customer Service.
Please check that the module is correctly connected. Check that the
file copied in the USB stick is not damaged.
Turn power off, then turn it on and try the software update again.
Please try the software update again or contact Customer Service.
NANO is inside its working area.
TM
NANO will go to its base and stay there. Please note Mission
TM
NANO.
TM
NANO to work. It's time to recover it for winter
TM
NANO to the Wi-Fi network it has been
TM
NANO runs out of charge, take it manually to the
TM
NANO in the charging
TM
NANO
TM
15
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido