Publicidad
Idiomas disponibles
Idiomas disponibles
4
7.
hole saw, drill two holes at the locations indicated on the template. Using a panel saw, carefully cut away the material
along the dotted line. Be sure NOT to cut into the existing clip slot below the dotted line area.
8. Install new LED Bezel (A) using one (1) phillips
screw from inside the fascia. Feed the connector
harness through to the inside. Be sure to press
the two (2) retaining clips firmly into position.
9.
11/29/12
Trim out template B and tape into position on fascia. Using a drill and 7/8 inch
Do not cut
into existing clip slot.
Publicidad
