Mopar 82213170 Instrucciones De Montaje página 9

20. Place the control module (E) into position inside
the edge of the fender. Reinstall two (2) 10mm nuts
to secure the module.
21. Plug the connector ends from the power harness (D)
and the lamp harness (C) into the control module.
Route the harnesses down between the fuse box
and the inside of the fender wall and secure with
cable ties as needed.
22. Reconnect battery ground cable and perform a functionality test at this time.
23. Raise the vehicle and reverse Step 4 to reinstall the lower cover panel.
11/29/12
9