Ddin Head Unit Provision - Metra 99-5826CH Instrucciones De Instalación

DDIN head unit provision

1. Locate the factory wiring harness in
the dash. Metra recommends using the
proper mating adapters from Metra and
AXXESS to integrate your new radio.
Re-connect the negative battery
terminal and test the unit for
proper operation.
2. Cut and remove the center bar from
the radio housing. (Figure A)
3. Snap the Double DIN brackets to the
inside edge of the Double DIN trim
plate. (Figure B)
4. Slide the Double DIN head unit or
stacked ISO head units into the
bracket/radio housing assembly and
secure the Double DIN head unit or
stacked ISO head units to the assembly
using the screws supplied with the
radio. (Figure C)
5. Snap the double DIN trim plate into
the radio housing.
6. Plug the A/C harness into the car side
of the climate control plug and the other
side into the kit
7. Reassemble dash in reverse order of
disassembly using the 99-5826CH
radio trim panel instead of the
factory radio trim panel.
Kit Assembly 99-5826CH
5
(Figure A)
(Figure B)
(Figure C)