Kit Assembly; Iso Din Head Unit Provision With Pocket - Metra 99-5826CH Instrucciones De Instalación

ISO DIN head unit provision with pocket

1. Locate the factory wiring harness in
the dash. Metra recommends using the
proper mating adapters from Metra and
AXXESS to integrate your new radio.
Re-connect the negative battery
terminal and test the unit for
proper operation.
2. Mount the ISO Brackets to the head unit
with the screws supplied with the unit.
(Figure A)
3. Snap the pocket into the bottom
opening of the radio housing. (Figure B)
4. Slide the head unit into the radio
opening until the side clips engage.
(Figure B)
5. Snap the Trim plate into the Radio
Housing. (Figure C)
6. Plug the A/C harness into the car side of
the climate control plug and the other
side into the kit
7. Reassemble dash in reverse order of
disassembly using the 99-5826CH
radio trim panel instead of the
factory radio trim panel.
Kit Assembly 99-5826CH
4
(Figure A)
(Figure B)
(Figure C)