Operation; Switching On/Off - Vacmaster VQ1220PFC Manual Del Usuario

8) Choose the desired accessories and/or extension wands and push fit onto the hose nozzle.

1. Switching On/Off

Connect the mains plug to a suitable a power outlet.
Position
I
O
II automatic synchronized start-up
2. Power Tool Take-Off Operation (Fig. 7)
WARNING:
off socket against the desired power tool before connecting to prevent overloading.
1) Connect the power cable of your power tool to the power take-off socket.
2) If applicable, connect the vacuum suction hose to the dust extractor connector on your tool with
the supplied adaptor.
3) Switch the vacuum cleaner to position II, as described in Switching ON/OFF. The moment you
switch on the power tool, the vacuum cleaner will also switch on. Once the electrical appliance
has been switched off, the vacuum cleaner switches off following a time lapse (around 5
second) to allow the suction tube to be emptied.
3. Dry & Wet Vacuum Operation
WARNING!
'SAFETY INFORMATION'.
1) Verify that the correct filter is installed for wet or dry vacuuming and the container latches are
secured.
2) Secure the locking end of the hose into the vacuum suction port.
3) Push the desired accessories onto the hose nozzle.
4) Plug the power cord into a power outlet.
5) Turn on the motor by assigning the switch to the "I" ON position.
6) Once you have completed vacuuming, switch to the "O" OFF position and unplug the power
cord from the power.
For Dry Vacuuming:
WARNING:
CLEANER FILTER, ENSURE THAT THE POWER CORD IS UNPLUGGED AND
SWITCHED OFF.

OPERATION

Status
on
off
Always check the maximum wattage compatibility of the power tool take
ENSURE YOU READ, UNDERSTAND AND APPLY SECTION ENTITLED
BEFORE INSTALLING, REMOVING OR CLEANING THE VACUUM
9
GB