Replacement Of Faulty Components; Disposal And Recycling; Liability - Satelec PIEZOTOME Manual De Uso

FAULT
Mode (in P
IEZOTOME
function) or power
range (In N
EWTRON
function) cannot be
changed
The irrigation circuit
cannot be flushed
Active connection
(left/right) cannot be
switched

7. 2 REPLACEMENT OF FAULTY COMPONENTS

For the technical staff of agents in its distribution
network, SATELEC will provide all the information
necessary for the repair of faulty components
that SATELEC considers as reparable.
VIII - DISPOSAL AND
RECYCLING
In no circumstances should worn out equipment
be disposed of by the user.
The presence of this symbol
product should not be treated as household waste
but must be processed separately, in line with
Directive 2002/96/CE.
By making sure that this product is disposed of
correctly, you are helping to protect the
environment.
For more information on the recycling of this
product, please contact your local authority, an
official dump or the outlet where you bought the
product.
POSSIBLE CAUSE
The device is emitting
ultrasound
There is no cord plugged into
the connector
The device is emitting
ultrasound
There is no line plugged into
the handpiece
The device is emitting
ultrasound
There is no cord plugged into
the connector
means that this
Stop ultrasound by stepping on the footswitch (Figure
6, #2)
Check that the handpiece cord is correctly connected
to the connector
Stop ultrasound by stepping on the footswitch (Figure
6, #2)
Check that the irrigation line is correctly connected to
the handpiece
Stop ultrasound by stepping on the footswitch (Figure
6, #2)
Check that the handpiece cord is correctly connected
to the connector
• Used irrigation lines should be disposed of in a
special contaminated waste container.
• Used tips should be disposed of in special safety
containers.
IX - LIABILITY
The manufacturer is not liable if:
• the manufacturer's recommendations have not
been followed (see Chapter 2),
• repairs have been performed by anybody other
than an engineer
manufacturer
• the device has been used in an electrical
installation which does not comply with current
standards,
• the device has been used in a way which is not
stipulated in this manual,
• the instructions in this document have not been
followed.
22
REMEDY
authorized by the