Descargar Imprimir esta página

Mopar 82214097 Instrucciones De Montaje página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

26. Reinstall the outer casing on the connector.
Plug all connectors back into the BCM.
27. Reinstall the rubber grommet under the dash.
Apply RTV sealant around the access hole that
was cut in the grommet to seal the switch harness.
Bundle and secure any excess wiring harness
under the dash with a cable tie.
1. Reconnect battery.
2. Connect a battery charger to the vehicle.
3. Log into DealerConnect and perform single VIN inquiry. Select the options tab and be sure sales code XBM is listed
in the dealer installed options section.
4. Log into WiTech and perform restore vehicle configuration routine from the diagnostics tab or vehicle prep tab.
5. After exiting the routine, remove battery charger and disconnect the negitive battery cable from the battery.
9/19/13
11

Publicidad

loading

Este manual también es adecuado para:

8221388182215104ab