Descargar Imprimir esta página

Mopar 82214097 Instrucciones De Montaje página 17

Publicidad

Idiomas disponibles

Idiomas disponibles

1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select the "DIAGNOSTIC PROCEDURES" tab
• Select “RESET ECU”, then click “NEXT” and select “RFH” on list then click “RESET”
• Wait for confirmation that the ECU has reset. This will take several seconds
• Select "CLOSE"
3. Close and restart WiTech tool program and WiTech server application.
4. Clear all stored DTCs.
1. Sit in the driver seat and close the door.
2. Lower the window part of the way down.
3. Run the window to the full up position and continue to hold the switch for an additional two seconds.
4. Run the window to the full down position and continue to hold the switch for an additional two seconds.
5. Raise the window to the full up position.
6. Repeat the steps for the remaining windows.
1. Connect a battery charger to the vehicle.
2. With the wiTECH diagnostic application, perform the following steps:
• Select "BODY CONTROL MODULE (BCM)"
• Select the "MISC FUNCTIONS" tab
• Highlight and select "REMOTE START TEMPORARY DISABLE"
• Note OnScreen instructions and select the "NEXT" button
• Select the "CONTINUE" button to activate the remote start function
• Select "SAVE" the remote start setting, then hit “CONTINUE”
• Wait for confirmation that the setting has been saved and BCM has been reset
• Select "CLOSE"
To activate the remote start the vehicle must be driven at least 35 MPH.
With the vehicle off, and the doors closed and locked, verify the remote start is functioning properly.
9/19/13
17

Publicidad

loading

Este manual también es adecuado para:

8221388182215104ab