Transportation, Storage And Disposal - Husqvarna W520i Manual Del Usuario

Battery charger
LED on the battery
charger
The error LED flash-
es
The error LED is on
Control panel
Error code (Number
of flashes)
1
5
8
9
10
Other errors
Introduction
WARNING: To prevent unintentional start
during transport pull up the safety key,
remove the battery and wait at least 5
seconds.
To set the product in transport position
1. Loosen the lower knobs.
2. Move the knobs to the lower end of the grooves on
the left and the right side of the product. (Fig. 30)
3. Fold the handle forward. (Fig. 65)
4. Remove the grass catcher.
Transportation
• The Dangerous Goods Legislation requirements
apply to the contained Li-ion batteries.
28
Possible faults
The temperature in the work en-
vironment is too high or too low
Possible faults
The transmission motor is too hot.
The motor speed decreases too much, and
the motor stops.
The battery is weak.
Battery error or no signal from battery.
The motor control is too hot.
If other errors occur, remove the safety key and the battery and speak to an approved serv-
ice agent.

Transportation, storage and disposal

Possible procedure
Use the battery charger in temperatures between 5°C
and 40°C.
Speak to an approved service agent
Possible procedure
Let the product become cool. Make sure that
the transmission does not have grass on it.
Clean the transmission cover if it is necessa-
ry.
Clean the cutting deck and increase the cut-
ting height. Refer to
on page 24 . If the error stays, speak to your
approved service agent.
Charge the battery. Refer to
battery on page 24 .
Put the battery in the product correctly and
examine the battery connector. If the error
LED on the battery flashes, refer to
on page 24 .
Stop the motor and wait until it is cool.
• For commercial transports special requirements on
package and labels must be obeyed.
• Make sure that you obey the regulations for
dangerous material when you prepare the product
for transport. Local regulations can apply.
• Always remove the battery for transport.
• Put tape on the battery connectors and make sure
that the battery cannot move around during
transport.
• Attach the product during transport.
Storage
• Always remove the battery for storage.
• To prevent accidents, make sure that the battery is
not connected to the product during storage.
• Keep the battery charger in a closed and dry space.
• Keep the battery and the battery charger in a dry
space where there is no moisture or frost.
To set the cutting height
To charge the
Battery
1484 - 001 - 30.04.2020