Fossil 515.2 Manual Del Usuario página 4

Chronograph
JS15, JS16, JS26, JS10
24-HOUR HAND
CHRONOGRAPH
MINUTE HAND
CHRONOGRAPH
SECOND HAND
DATE SETTING
1 . Pull crown out to position 2 .
2 . Rotate clockwise to set date .
3 . Return crown back to position 1 .
TIME SETTING
1 . Pull crown out to position 3 .
2 . Rotate clockwise to set time .
3 . Return crown to position 1 .
CHRONOGRAPH
1 . Press A to start/stop the chronograph .
2 . Press B to reset to zero .
CHRONOGRAPH ZERO RESET
1 . If either of the chronograph hands is not at the zero (12:00) position, pull
crown out to position 3 .
2 . Press A to rotate hands clockwise; press B to rotate hands counter-clockwise .
3 . Each press of A or B will move the chronograph hands by one increment/
decrement . Press and hold A or B for fast increment/decrement .
4 . When both hands are in the zero position, reset time and return crown to
position 1 .
NOTE: Chronograph minute hand will synchronize with chronograph second
hand during chronograph zero reset.
6
CHRONOGRAPH
MINUTE HAND
CHRONOGRAPH
24-HOUR HAND
SECOND HAND
Chronograph Stopwatch
1/10 SECOND HAND
MINUTE HAND
SECOND HAND
DATE SETTING (on some models only)
1 . Pull crown out to position 2 .
2 . Rotate clockwise to set date .
3 . Push crown back to position 1 .
TIME SETTING
1 . Pull crown out to position 3 .
2 . Rotate clockwise to set time .
3 . Return crown to position 1 .
USING THE STOPWATCH
1 . Press A to start/stop the stopwatch .
2 . Press B to control the split time and reset .
STOPWATCH HAND ADJUSTMENT
1 . Pull crown out to position 3 .
2 . Press A to reset the stopwatch 1/10 second hand to the "0" position .
3 . Press B to reset the second and minute hands .
4 . Each press of A or B will move the chronograph hands by one increment/
decrement .
Press and hold A or B for fast increment/decrement .
NOTE: If the stopwatch hands function improperly, pull out crown and press A
and B at the same time for over 2 seconds. When the pushers are released,
the stopwatch second and 1/10 second hands will spin around and return to
"0." This will indicate that the internal circuit has been reset.
VD57B
A
B
7