Ryobi CLT-1423P Manual De Utilización página 18

GB
F D
FEATURE
Fig. 6
A. BATTERY PACK
B. BATTERY CHARGER
C. YELLOW LIGHT
D. GREEN LIGHT
E. RED LIGHT
Fig. 7
A. BATTERY PACK
B. LATCHES
Fig. 8
A. TRIGGER LOCK BUTTON
B. TRIGGER
Fig. 11
A. CUT OFF BLADE
Fig. 13
A. BUMP KNOB
B. SLOT ON SPOOL
C. SPOOL CAP
D. TABS
E. SPOOL
F. SPRING
G. SPOOL HOUSING SLOT
H. OPENING IN SPOOL HOUSING
I. SPOOL HOUSING
ASSEMBLY
INSTALLING GRASS SHIELD
Remove both screws on the motor housing.
■
Orient grass shield on the motor housing and twist to
lock in place as shown.
Re-install screws to secure grass shield in place.
■
See Figure 2.
ADJUSTING THE SHAFT
Rotate the lower portion of the shaft adjustment collar
■
to the "Unlock" position. See Figure 3.
Lower shaft should now be free to slide down from
■
inside the upper shaft. Make sure the shaft is pulled
out to the desired position. See Figure 4.
Rotate shaft adjustment collar to the "Lock" position
■
and tighten securely. See Figure 5.
WARNING
If any parts are missing, do not operate unit until
the missing parts are replaced. Failure to do so
could result in possible serious personal injury.
E I P NL S DK N FIN
English
OPERATION
LED FUNCTIONS OF CHARGER
See Figure 6.
LED WILL BE ON TO INDICATE STATUS OF
CHARGER AND BATTERY PACK:
Red LED on = Fast charging mode.
■
Green LED on = Fully charged battery pack.
■
Yellow and Green LEDs on = Control charge or
■
defective battery pack.
No LED on = Defective charger or battery pack.
■
CAUTION
To prevent damage to battery pack, remove
battery pack from charger immediately if no LED
comes on. Return battery pack and charger to
your nearest Authorised Service Centre for
checking or replacing. Also, if you are removing
battery pack from charger and no LEDs are on,
return both battery pack and charger to your
nearest Authorised Service Centre. Do not insert
another battery pack into charger. A damaged
charger may damage a battery pack.
CHARGING YOUR BATTERY PACK
The battery pack for this unit has been shipped in a low
charge condition to prevent possible problems.
Therefore, you should charge it prior to use.
NOTE: Batteries will not reach full charge the first time
they are charged. Allow several cycles (trimming followed
by recharging) for them to fully charge.
TO CHARGE
Charge battery pack only with the charger provided.
■
Make sure power supply is normal household
■
voltage, 230 volts, 50 Hz, AC only.
Connect charger to power supply.
■
Place battery pack in charger. See Figure 6. Align
■
raised rib on battery pack with groove in charger.
When charger is properly connected, red light will
■
turn on. Press down on battery pack to be sure
contacts on battery pack engage properly with
contacts in charger.
Normally, the yellow and green lights on the charger
■
will come on. This indicates charger is in control
charge mode and should switch to fast charge mode
within 5 minutes. When charger is in fast charge
mode the yellow and green lights will go off and the
red light will come on.
13
GR H CZ RUS RO PL