Tacx T1670 Manual Del Usuario página 53

Failure
6 Cycling power 1 The mag unit does not brake
seems less than
shown on the display
2 The mains voltage is too low
3 Several magnets of the mag
4 The print plate of the mag
7 Cycling power 1 The bike chain is worn
seems higher than
shown on the display
2 Tyre pressure is too low
3 The mag unit is not yet warm
4 The ambient temperature is
8 The pedalling 1 The cadence sensor has not
frequency remains
zero
2 The sensor was installed out
3 There is a break in the
4 The sensor plug is not con-
9 The cycle speed 1 The speed impulses do not
remains zero
2 The bike wheel does not
3 The speed sensor in the mag
Potential problem
properly or at all
unit are loose due to having
been dropped
unit is burned out
too low
been connected or the
magnet has fallen out of the
magnet holder
of range of the magnet
cadence sensor cable
nected properly to the mag
unit
reach the computer
reach the mag unit roller
unit is defective
GB
Solution
1 Check the cable and plug contacts in
the computer and the mag unit. They
could be dirty, oxidised or bent
2 The Basic works properly between
220 and 230 V/50Hz.
3 The lid of the mag unit should be
replaced
4 The print plate should be replaced
1 Replace the chain
2 Make sure the rear tyre pressure is
good
3 The mag unit will be warm after about
three minutes of cycling
4 Usethe Basic at ambient temperatures
between 5º C and 35º C (40ºF & 95º)
1 Connect the sensor or install a good
magnet
2 Make sure, the distance between the
sensor and the magnet is about 3 mm
3 Connect a new sensor
4 Check whether the plug is completely
in the connection
1 Check the cable and the plug contacts
in the computer and the unit. They
could be dirty, oxidised or bent
2 Adjust the mag unit with the adjust-
ment knob, so that the tyres cannot
slip
3 A new print plate will have to be
installed in the magnet unit
Error messages
53