BH FITNESS G2346 Manual De Instrucciones página 14

If the error code "E1" is shown on the
screen then this means that you do
not have your
correctly on the hand-grip sensors (R).
If the error code "E2" appears on the
screen, this means that you have not
stopped exercising.
FITTING THE ELECTRONIC
MONITOR.-
FITTING THE HAND-GRIP CABLE
(Pulse sensors)
Take cable (54-55) coming out of the
handlebar stem and connect it to
cable (54a-55a) coming out of the
monitor, Fig.5.
FITTING THE MAIN CABLE
Connect the terminal block (36a)
coming out of the monitor, Fig.5, to the
terminal block (36) coming out of the
handlebar stem. Remove the screws
(2) from the base of the monitor and
place the monitor on top of the
handlebar ítem (4), making sure not to
catch any of the cables, and attach it
by using the
previously.
TROUBLESHOOTING GUIDE
Problem: The display comes on but
only the Time function Works.
hands positioned
screws removed
Solution:
a.-Make sure that the connection
cable is connected.
(Transformer 6V-1000 m Amp)
Problem: The monitor does not
switch on.
Solution:
a.- Check
connection
b.- Check the output connection from
the transformer to the monitor.
c.- Check
connections.
d.- Check the cable connections for
the main post.
Avoid leaving the electronic monitor
in direct sunlight as
damage the liquid crystal display.
Similarly, do not expose it to water or
knocks.
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
Do not hesitate to get touch with us if
you have any queries, by calling:
+44 0844 335 3988
service@bh-uk.co.uk
14
the 220 V
the monitor
this might
mains
cable