Default Settings; Country; Intrusion; Eco Mode - Motorola D710 Serie Manual De Instrucciones

D711_IFU_EN_for_EU.book Page 18 Friday, August 24, 2007 3:58 PM
NOTE
Make a note of your PIN. If you forget your PIN you will need to reset your product.
Reset
This will reset your D711 to its default settings.
m d m
1. Press , scroll to ADVANCED SET and press .
d m
2. Scroll to RESET UNIT. Press .
m
3. CONFIRM? is displayed. Press .
NOTE
Entries stored in the phonebook and new answering machine messages are retained. After reset,
depending on your country, the welcome mode setting may be shown on the handset display.

Default settings

Handset name
Key tone
First ring
Auto pick up
Auto hang up
Ringer melody
Ringer volume
Earpiece volume
Phonebook
Call log
Redial list
Master PIN
Keypad lock
Clock
Alarm
Dial mode
Answer Machine
Answer Mode
Outgoing message
Ring delay
Remote Access
Handset screening
Base screening
18
Auto prefix
You can set the D711 to detect a dialling number and replace it with another number. The number
to be detected can be up to 5 digits long. It can be replaced with a number up to 10 digits.
m
1. Press , scroll
d
2. Scroll to PREFIX. Press
3. DETECT DIGIT
4. Enter the number you want to be detected and press
5. Scroll to PREFIX
6. Enter the number you want it replaced with and press
>
7. Press to return to standby.

Country

If you move to another country you can set your phone to be compatible with the network settings
of that country.
Handset
NOTE
On
If you make a mistake during welcome mode country selection, you can also reset your country.
On
Depending on your country, this option may be displayed as
On displayed.
m
1. Press , scroll
On
d
2. Scroll to
Ring 1
3. Enter the 4-digit master PIN and press
u
High 4. Scroll or
m
5. Press to confirm.
3

Intrusion

Unchanged
When an external call is taking place, another handset registered to the base can join in, making
Empty
the call a 3-way conference, just by pressing
Empty
To enable this, Intrusion must be switched On.
m
0000
1. Press , scroll
d
2. Scroll to INTRUSION. Press
Off
u
3. Scroll or
m
00:00
4. Press to confirm.
>
5. Press to return to standby.
Off

ECO mode

Tone
To reduce the level of power emissions, you can select low power or ECO mode. When the ECO
On
mode is set to ON, the base transmission power will be reduced.
Answer & Record
To turn ECO Mode to
Pre-defined
m
1. Press , scroll
d
15 seconds
2. Scroll to
u
3. Press or
On
- A confirmation beep is emitted and the handset display will switch between the handset's
Off
name and
NOTE
On
When Eco Mode is set to ON, the handset range will be reduced.
d m
to ADVANCED SET and press .
m
.
m
is displayed. Press .
m
.
m
NUM. and press .
m
.
NOT AVAIL
d m
to ADVANCED SET and press .
m
SEL. COUNTRY. Press .
m
.
d
to display the required country.
<
.
d m
to ADVANCED SET and press .
m
.
d
to ON or OFF.
ON or OFF:
d m
to ADVANCED SET and press .
m
ECO MODE and press .
d m
to highlight ON or OFF then press to confirm.
ECO MODE.
or you country may not be
Advanced settings